Re: SuSE 9.3 64-Bit and problems with booting from usb-stick

[Peter_22@xxxxxx]

Jari Ruusu <jariruusu@xxxxxxxxxxxxxxxxxxxxx> wrote:

> Can you post exact error message that you see?
Booting from usb-stick like this:
usb initrd=stick root=100 init=/linuxrc rootfstype=minix vga=0x317
kernel loads...
....

Attached scsi removable disk sdb at scsi2, channel 0, id 0, lun 0
Attached scsi generic sg1 at scsi2, channel 0, id 0, lun 0, type 0
Command "/lib/loadkeys /lib/default.kmap" returned error
Command "/lib/insmod /lib/modules-2.6.11.4-20a-default/loop.ko" returned
error

md: stopping all md devices
md: md0 switched to read-only mode
...
system halted


Files default.kmap is there, folder modules-2.6.11.4-20a-default and loop.ko
is there, too. I guess the binaries loadkeys and insmod lack some libraries
or have been linked in an unusable way.

Is there more information I can give? I would like to get it working
properly as under SuSE 9.2 64bit before. En/decryption of pure data
partitions works fine with suse 9.3. There was no difficulty to set it up
again.



Regards,
Peter

-- 
+++ NEU: GMX DSL_Flatrate! Schon ab 14,99 EUR/Monat! +++

GMX Garantie: Surfen ohne Tempo-Limit! http://www.gmx.net/de/go/dsl

-
Linux-crypto:  cryptography in and on the Linux system
Archive:       http://mail.nl.linux.org/linux-crypto/